[+]
SORT Support
[+]
SORT Suggestions
Error Code details
V-5-1-587
Severity: Error 
Component: Volume Manager 
Message:
disk group groupname import failed: reason
Description:

There’s a second part of the error message, which varies depending on the context. The following table shows where to find the description and solution for each message.
 

Message

Description

See ...

Disk is in use by another host

The message appears when you try to import a disk group with disk(s) moved from a crashed system, or from a system that fails to detect the group before the move. The locks stored on the disks must be cleared.

Solution 1

No valid disk found containing disk group

The disk group does not contain any valid disks (but it might contain disks). A mismatch between the host ID in the configuration copies and that stored in the /etc/vx/volboot file may make the disks invalid.

Solution 1
Disk for disk group not found The message appears because the disk(s) is not accessible after last successful import of disk group, which is a recoverable error. Solution 2
Disk group has no valid configuration copies The error message indicates a fatal error that requires hardware repair or the creation of a new disk group, and recovery of the disk group configuration and data. Solution 2

 

Note: Solution 3 applies to all the above messages.

 

Symantec solutions
Solution 1 Vote: [Useful] [Not useful]
Last Modified: 2013-03-21 02:21:43 PDT
Platform: Generic
Release: Generic
Content:

Clear the locks by either of the following ways:

 

  • Clear the locks on a specific set of devices:
     

# vxdisk clearimport devicename ...
 

  • Clear the locks during import:
     

# vxdg -C import diskgroup
 

Warning: When you use the vxdisk clearimport or vxdg -C import command to clear the locks, make sure that the disks in this disk group are not in use by another host. If the disks are in use by another host, clearing the locks allows the disks to be accessed at the same time from multiple hosts. This can result in data corruption.

Solution 2 Vote: [Useful] [Not useful]
Last Modified: 2013-03-21 02:20:47 PDT
Platform: Generic
Release: Generic
Content:

Force the disk group to be imported by running command:
 

# vxdg -f import diskgroup


The -f option forces an import if one or more disks are currently unusable or inaccessible. When you use the -f option to force the import of an incomplete disk group, it counts as a successful import. The next time this disk group is imported, the -f option is no longer required. The import completes successfully as long as all the disks in this disk group are accessible.

 

Warning: Be careful when you use the -f option. It can cause the same disk group to be imported twice from different sets of disks. Consequently, the disk group configuration may become inconsistent.

Solution 3 Vote: [Useful] [Not useful]
Last Modified: 2013-03-21 02:23:27 PDT
Platform: Generic
Release: Generic
Content:

You can also use the vxdiskadm utility to clear the locks or force the disk groups to be imported:

 

  • Select the menu item “Enable access to (deport) a disk group” to deport a disk group.
     
  • Select the menu item “Enable access to (import) a disk group” to import a disk group.

 

The vxdiskadm import operation checks for host import locks and prompts to see if you want to clear any that are found. It also starts volumes in the disk group.

 

User solutions
No user solutions yet.

 

Feedback
Click here to rate this page
Read and accept Terms of Service